A Pillar Finisher Cap (Unpainted) for Land Rover Defender L663 - LEFT 1" There is no soldering needed

There is no soldering needed to fit this kit - we have pre soldered the switch and put solder on the end of the leads - the only thing you need to do is drill the small hole in the rear door "dish"

9pc Door & Tailgate Handle Cover Set - Tasman Blue

These mirror covers are shaped to 'hug' the wing mirror and almost snap into place and there is a small section of adhesive tape to secure the cover

There is no cutting or splicing of your original vehicle wiring as you use our custom tap-in looms which simply plug into place to give you a power feed from the reverse light

A Pillar Finisher Cap (Unpainted) for Land Rover Defender L663 - LEFT 1" There is no soldering neededLEFT A Pillar Lower Finisher Cap (Unpainted) for Land Rover Defender L663 This listing is for a left hand genuine Land Rover A Pillar finisher cap for the Land Rover Defender L663. IMPORTANT INFO: The design of the A Pillar finisher and cap changed sometime in 2020 this is the late type cap and is not compatible with the early type a pillar finisher (see photo). This is the small finisher cap at the bottom of the A Pillar. This finisher cap clips off